High Build Epoxy Primer is an epoxy surfacer used where high build and filling is required. For above waterline use only. Product Components, Reducers, Additives, and Auxiliary Components
Yellow Base................................................D9002
Off White Base ..........................................D8002
Converter ..................................................D3002
Standard Reducer for Epoxy Primers .............T0006
Medium Evaporating VOC Exempt Reducer (NA only) ........T0176
Equipment Cleaning: Acetone, T0006, T0176, T0002 Reducers or M.E.K.
Surface Preparation
Best when used as a surfacer over other Awlgrip Primers and fairing compounds. May be applied directly to properly prepared wood or fiberglass; however, best results are obtained when these surfaces are first sealed with 545 Primer. Gelcoat/Fiberglass: Sand with 100-150 grit paper. Wood: Smooth sand with 80-100 grit paper.
Mixing and Reduction
Mix by volume one part Base with one part Converter to a smooth, homogenous mixture.
Induction Time after Mixing: 15 Minutes
Reduce 10-20% with appropriate reducer. Example: 8 oz. Base : 8 oz. D3002 : 3.2 oz. T0176
Anticipated Pot Life at 77øF(25øC)/50% R.H: 8 Hours. Higher temperatures may shorten pot life.
Application Instructions
Spray: Apply High Build Epoxy Primer in even coats of 8 - 10 mils (200 - 250 microns) wet film thickness yielding 4 - 5 mils (100 - 125 microns) DFT. 2 - 3 coats may be required.
Do not apply paint materials to surfaces warmer than 105øF (41øC) or colder than 55øF (13øC). Do not attempt to cure products at temperatures below 55øF (13øC).
High Build Epoxy Primer is an epoxy surfacer used where high build and filling is required. For above waterline use only.Product Components, Reducers,...
Customers who bought this product also purchased...
GRIPTEX Non-Skid-Fine Grit 73012 QT
Griptex is a polymer bead aggregate used to provide non skid deck and step areas when mixed with an Awlgrip topcoat. Type: Polymer BeadColor: Transluc...
Griptex is a polymer bead aggregate used to provide non skid deck and step areas when mixed with an Awlgrip topcoat. Type: Polymer BeadColor: Transluc...
545 Epoxy Primer is a multi-use epoxy primer used to seal filler primers and fairing work before applying topcoats. For use above and below the waterl...
Awlgrip AwlCat #2 Standard Spray Converter is to be used with Awlgrip when spraying only or with AwlCraft 2000.Awlgrip Converter: Ratio 1:1, Mix in a ...
Awlgrip AwlCat #3 Brushing Converter is to be used with AWLGRIP ONLY when brushing or rolling.Mixed in a one-part converter to two parts color base ratio.
.jpg "Awlgrip High Build Epoxy Primer Converter, D3002, QT")
.jpg "545 Epoxy Primer Gray Base D1001 GL")
.jpg "545 Epoxy Primer Converter D3001 GL for D1001 and D8001")
