Application of Topside Paint Mega Gloss Gold and Mega Gloss by Blue Water

Learn how to apply Mega Gloss Gold and Mega Gloss by Blue Water Marine Paints

mega glossPrepping & priming for topside work
Mega Gloss Gold and Mega Gloss by Blue Water Paint provide a beautiful aesthetic finish, and also provide protection against – sea, rain, wind and sun.
Blistering UV rays will degrade the surface of fiberglass and prematurely age your vessel. Moisture can also cause as many problems for wooden vessels and metal boats.

  • Clean and prepare the hull by first washing with soap and water and finish with fresh water. Then wipe the surface with a rag that has been dampened with 974 Reducer.
  • After preparing the surface, sand with 220-320 grit wet-or-dry sandpaper. Remove sanding residue by wiping with a rag that has been dampened with 974 Reducer.
  • Apply 1-2 coats of primer, and 2-3 coats of Finish Paint. Sand between coats with 320-400 grit. If the paint is peeling, cracking or generally showing signs of separations over the whole area, you need to remove the coating.

Applying topside paint
• Stir the paint thoroughly using a stir stick. Stir the can occasionally during work.
• Application methods for all paints include brush,roller or spray.
• It is best to paint on warm dry mornings – cold weather retards the drying of paint and dampness will spoil the gloss.
• Brush – Long flexible bristles are best for gloss paints. Apply by brush, spreading with horizontal strokes before finishing with light vertical strokes. To minimize brush marks, hold the brush at a 45° angle.
• Roller – A good gloss can be obtained using a high density / small cell foam roller. This will minimize the formation of bubbles in the surface. It is best to roll in one direction and tip off in another direction.
• Thinners can be added as you work to maintain working viscosity. Use 974 Thinner as needed for proper flow and performance.
• Pour the amount you expect to use in 30 minutes into a separate container.
• Once topcoat painting is complete, it should be kept dry for at least 24 hours, and 7–10 days should be allowed for full curing to take place.
• Do NOT use or incorporate any flow control agents like Penetrol®.

Topside paint hints / tricks
mega gloss Mega Gloss Gold™ and Mega Gloss™ can be made to be a non-skid texture for decks by the addition of Blue Water Non-Skid Additive, by adding to the paint and applying 2 coats. The non-skid additive comes in S grade regular and T grade coarse.

  • Application of a topside primer will provide additional depth of color, adhesion and durability.
  • The best method is to apply with a roller, and then tip off with a large brush with long flexible bristles.
  • Use a diagonal brushing method at 45 degrees, followed by horizontal and then vertical strokes.
  • The best roller is a solvent resistant foam roller, which will reduce bubbles.
  • Use a top quality fine line masking tape for good crisp lines and no residual glue left on the hull.

Why do the majority of boaters paint with 1-part paint?
Alkyd enamels, and modifications of alkyd enamel technology, have been the work horse products in the marine industry for approximately fifty years. Generally, they dry reasonably fast, are easy to apply and have very good weathering characteristics. More alkyd enamels are still used than any other enamel type.

Can topside paints be applied to below water surfaces?
Most topside coating systems if constantly immersed or kept wet will tend to blister. Provided the boat is only put into the water for a few days then a topside coating can be used below the waterline.

What’s the best way to get a good finish with topsides paints?
You must lightly sand the surface and then use a good roller or brush. Thin when needed for proper flow and performance